User Manual

zBoost
®
Xtreme ZB545X Manual
zBoost
®
Xtreme ZB545X Manual
4 5
securing the cable into a loop (no less than 4” across) near the
entry point. This will help prevent moisture from gathering at
entry point and leaking into the home. Consult a professional
installer if you need more information.
Power Requirements
The Base Unit can be plugged into a standard 2 or 3 prong
110 VAC receptacle using the Included power supply. The
power supply consumes less than 10W (less than 0.2A).
Coax Cable
Exterior Wall
Setting Up Your zBoost Signal Booster
FIRST: Mount the External Antenna
Choosing the best location for the External Antenna
provides the best performance and the largest area
of improved signal. Choose a location for the External
Antenna using your cell phone to determine the area
of strongest signal - typically found outside, above the
roofl ine or in an attic. The antenna must also remain at
least 3 feet from any metal objects such as pipes, metal
siding, A/C unit etc. and at least 15 vertical feet above the
Indoor Antenna.
Identify the best location for attachment of the mounting
bracket – such as an attic cross or main beam. Secure the
mounting bracket at the highest possible point. Position
the mounting bracket such that the External Antenna will
be vertical and attach the External Antenna. See “Antenna
Bracket Assembly” on page 6 for more information.
15’ of vertical
separation
15’ of vertical
separation
15’ of vertical
separation
Maximum Performance
Place External Antenna on roof
Note
The zBoost Xtreme ZB545X base unit MUST only be
used with the provided power adaptor. Use of other
power adaptors will void the warranty and may damage
the unit. Use of other equipment is not FCC approved.
Before installing, please note the following important factors in determining your zBoost
performance:
• At least 15 vertical feet is needed between the External Antenna (receives the outside signal)
and the Indoor Antenna (rebroadcasts the signal indoors). Separation less than 15 vertical feet
will result in decreased performance. See illustration below.
• Keep the External Antenna at least 3 feet above any metal.
See page 5, Setting Up Your zBoost Product, for additional information.
Additional Cable Requirements
RG-6 cable is used to connect the External Antenna and the Base Unit. Should you need additional
cable length, 15 foot extensions (Part #: YX030-15w) are available at www.zBoost.com.
The total cable length should not exceed 65 feet unless you also purchase an upgraded Signal
Antenna (see page v). A longer cable is helpful only if it allows you to place the External
Antenna in a location where you measure stronger signal.
Grounding the External Antenna
If you decide to place the External Antenna outdoors, it must be properly grounded. (See page
v for a recommended grounding kit).
The set up must be in accordance with Article 810 of the National Electric Code (NEC). A listed
antenna discharge unit must be provided for the lead-in coaxial cable per NEC article 8.10.20 or the
shield of the coaxial cable must be permanently and effectively grounded in accordance with NEC
article 8.10.21. Please consult a professional installer or electrician for more information.
Securing Cable with a Drip Loop
If you place the External Antenna outdoors, create a drip loop with the coaxial cable at the point
where the cable enters the home through an outside wall. This can be done by twisting and
Warning
Avoid placing the External Antenna near metal such as
wiring, A/C ducts, metal siding, truss plates, etc.
When connecting the cable to the antenna, run the
cable straight down from the antenna. Avoid draping
the coax near the antenna.
Maximum Performance Minimum Performance
15’ of vertical
separation
15’ of vertical
separation
15’ of vertical
separation