User's Manual

zBoost® YX741 User Manual

FCC ID: SO4YX741-PCS-CEL

WARNING.  is is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and

QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC Licensee

to operate this device. Unauthorized use may result in signi cant forfeiture penalties, including penalties in

excess of $100,000 for each continuing violation.

Warning: Changes or modi cations to this device not expressly approved by zBoost could void the user’s

authority to operate the equipment.

You MUST operate this device with approved antennas and cables as speci ed by the manufacturer.

Antennas MUST be installed at least 20 cm (8 inches) from any person.

FCC Information

Industry Canada Regulations

IC ID: 5544A-YX741PCSCEL

 is Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment

Regulations. Operation is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

 e term “IC:” before the radio certi cation number only signi es that Industry Canada technical

speci cations were met.

RF Exposure:  e manufacturer’s rated output power of this equipment is for single carrier operation.

For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB,

especially where the output is re-radiated and can cause interference to adjacent band users.  is power

reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the

device.

Cet appareillage numérique de la classe [B] répond à toutes les exigences de l’interférence canadienne

causant des règlements d’équipement. L’opération est sujette aux deux conditions suivantes: (1) ce dispositif

peut ne pas causer l’interférence nocive, et (2) ce dispositif doit accepter n’importe quelle interférence reçue,

y compris l’interférence qui peut causer l’opération peu désirée.

Le fabricant nominale de la puissance de sortie de ce matériel est simple transporteur. Pour les situations

lorsque plusieurs signauxporteurs sont présents, l’évaluation devrait être réduite de 3.5 dB, en particulier

lorsque le signal de sortie est ré-émise et peut provoquer des interférences adjacentes à la bande utilisateurs.

Ce pouvoir est de la réduction par le biais de la sortie d’alimentation ou la réduction de gain et non par un

atténuateur à la sortie du dispositif.

Please note:  is unit has been approved for use in Canada under RSS 131, however, consent for the use of

this device to improve cellular or PCS coverage, must be obtained through your cellular or PCS provider,

prior to placing the unit in operation. Please refer to the Industry Canada document CPC 2-1-05, Section

6.1 available or viewable at:

http://www.ic.gc.ca/epic/site/smt-gst.nsf/en/sf08942e.html