User guide

zBoost
®
SOHO Xtreme YX545x User Guide
4
zBoost
®
SOHO Xtreme YX545x User Guide
5
Before installing, please note the following important factors in determining your zBoost
performance:
• At least 15 vertical feet is needed between the Signal Antenna (receives the outside signal)
and the Panel Antenna (rebroadcasts the signal indoors). Separation less than 15 vertical feet
will result in decreased performance. See illustration below.
• Keep the Signal Antenna at least 3 feet above any metal.
See page 5, Setting Up Your zBoost Product, for additional information.
Additional Cable Requirements
Use the provided 50 feet of RG-6 cable to connect the Signal Antenna and the Base Unit. Should
you need additional cable length, 15 foot extensions (Part #: YX030-15w) are available at
www.Wi-Ex.com. RG-6 is also available at many home improvement or electronic stores.
The total cable length should not exceed 65 feet unless you also purchase an upgraded signal
antenna (see page iv). A longer cable is helpful only if it allows you to place the Signal Antenna in a
location where you measure stronger signal.
Grounding the Signal Antenna
If you decide to place the Signal Antenna outdoors, it must be properly grounded. (See page iv for a
recommended grounding kit).
The set up must be in accordance with Article 810 of the National Electric Code (NEC). A listed
antenna discharge unit must be provided for the lead-in coaxial cable per NEC article 8.10.20 or the
shield of the coaxial cable must be permanently and effectively grounded in accordance with NEC
article 8.10.21. Please consult a professional installer or electrician for more information.
Securing Cable with a Drip Loop
If you place the Signal Antenna outdoors, create a drip loop
with the coaxial cable at the point where the cable enters the
building through an outside wall. This can be done by twisting
and securing the cable into a loop (no less than 4” across)
near the entry point. This will help prevent moisture from
gathering at entry point and leaking into the building. Consult a
professional installer if you need more information.
Power Requirements
The Base Unit can be plugged into a standard 2 or 3 prong 110 VAC receptacle using the Included
power supply. The power supply consumes less than 10W (less than 0.2A).
Warning
Avoid placing the Signal Antenna near metal such as
wiring, A/C ducts, metal siding, truss plates, etc.
When connecting the cable to the antenna, run the
cable straight down from the antenna. Avoid draping
the coax near the antenna.
Note
The zBoost Xtreme YX545x base unit MUST only be
used with the provided power adaptor. Use of other
power adaptors will void the warranty and may damage
the unit. Use of other equipment is not FCC approved.
Maximum Performance Minimum Performance
15’ of vertical
separation
15’ of vertical
separation
15’ of vertical
separation
Coax Cable
Exterior Wall
Setting Up Your zBoost Signal Booster
FIRST: Mount the Signal Antenna
Choosing the best location for the Signal Antenna provides the best performance and the largest
area of improved signal. Choose a location for the Signal Antenna using your cell phone to
determine the area of strongest signal - typically found outside, above the rooine or in an attic. The
antenna must also remain at least 3 feet from any metal objects such as pipes, metal siding, A/C
unit etc.
Identify the best location for attachment of the mounting bracket – such as an attic cross or main
beam. Secure the mounting bracket at the highest possible point.
Position the mounting bracket such that the Signal Antenna will be vertical and attach the Signal
Antenna. See “Antenna Bracket Assembly” on page 6 for more information.