User guide

zBOOST® YX520 INTERNATIONAL USER GUIDE
ii
zBOOST® YX520 INTERNATIONAL USER GUIDE
iii
Read First Before Setting Up Your zBoost®
Before unpacking the contents, verify that your mobile phone operates on the frequency band supported by
this product.
• zBoost® YX520i will enhance your in-building coverage for local provider networks operating at
900MHz and 1800MHz frequencies.
Caution: Before beginning installation, you must have enough space
to provide 5 meters of vertical separation between the Signal Aerial and
Base Unit. Less than 5 meters will result in reduced performance.
To verify that your mobile phone will work in conjunction with the model purchased, please follow
these four simple steps:
Unpack the Base Unit, Base Unit Aerial and power supply.
1. Connect the Base Unit Arial to the Base Unit. Choose the
correct power adaptor for your geographical location and
attach to the power supply. Connect the power supply
to the Base Unit and plug into an outlet.  e signal light
should be solid green.
2. Now bring the unit (Base Unit, Power Supply and Base
Unit Arial) to an area where there is enough signal to
place a call (using an extension cord may be necessary).
Ifthe Signal light stays green while placing a call, you may
proceed to the next step: Setting up your zBoost® Signal
Booster. If it  ashes red, move your mobile phone further
away from the Base Unit and retry, it may be necessary to
disconnect the power for 10 seconds and then reconnect
the power.
3. If the Signal light does not stay a solid green, try placing
another call with your mobile phone next to the Base
Unit Aerial. If the Signal light still does stay green, your
mobile phone may be operating on a frequency that is not
supported by this zBoost model. Some carriers, change
frequency depending on location. Email Wi-Ex technical
support at [e-mail], or call 001.800.871.1612
for further assistance in identifying your frequency.
FIGURE 1: First, unpack the
Base Unit, Base Unit Aerial,
Power Supply and Adapters
Base Unit
Base Unit Aerial
Adapters & Power
Supply
1.  e equipment you purcahsed has required the extraction and use of natural resources
for its production. It may contain hazardous substances that could impact health and the
environment.
2. In order to avoid the dissemination of those substances in our environment and to diminish
the pressure on the natural resources, we encourage you to use the appropriate take-back
systems.  ose systems will reuse or recycle most of the materials of your end life equipment
in a sound way.
3.  e crossed-out wheeled bin symbol invites you to use those systems.
4. If you need more information on the collection, reuse and recycling systems, please contact
your local or regional waste administration.
5. You can also contact us for more information on the environmental performances of our
products.
International Certi cations