User's Manual

Wireless Extenders
i
YX500-CEL Installation Guide Rev. A
Read First Before Installing the YX500-CEL
YX500-CEL For Cell
Phones Operating
on Cellular 800MHZ
Frequencies Only
Before unpacking this box, verify that your phone operates on Cellular 800MHz
frequencies. The YX500-CEL will enhance your in-building coverage for local
provider networks operating at the 800MHz (Cellular) frequency.
To verify that your phone uses Cellular 800MHz frequencies, please follow
these four simple steps:
1) Unpack the Base Unit and the Base Unit power supply only.
2) Connect the power supply to the Base Unit and plug it into an outlet. All of
the lights will flash for several seconds. The Power light should now be solid
green.
3) While standing about 1 foot away from the Base Unit, turn on your cell phone
or make a call. If the Signal light begins flashing green, you can proceed
with the installation of the YX500. If it flashes red, move your phone away
from the Base Unit (typical for GSM).
4) If the Signal light does not flash green, try to place another call with your cell
phone directly touching the YX500 (typical for CDMA). If the Signal light still
does not flash green, your cell phone may not be compatible with the YX500-
CEL. Contact Wireless Extenders technical support at 1-800-871-1612 for
further assistance.
Note: The YX500 is fully automatic. The Install, Signal, and Power
lights on the Base Unit are not buttons. There are no buttons
to press on the Base Unit.