User's Manual

Wireless Extenders
9
YX500-CEL Installation Guide
Figure 8 - Attach Coaxial Cable to Antenna
Signal Antenna Mounting to an Attic Top or Main Beam
If a cross-beam is not available, the antenna bracket can be mounted to a main
beam. Secure the bracket near the top of the Signal Antenna instead of near the
base.
Figure 9 - Mounting Signal Antenna to a Main Beam
Running the
Coaxial Cable to the
Base Unit
After installing the Signal Antenna and connecting the coaxial cable, run it to
the location in your home where you plan to install the Base Unit. It is highly
recommended that you refrain from securing your cable, drilling any holes, etc.
until you complete and test the installation of the Base Unit.
For example, if you plan to use put the Base Unit in the living room of a two-
story home, first run the cable from the attic down the stairs to the living room.
After the Base Unit is installed and successfully working, find a more direct and
permanent route for the cable (e.g., dropping it through the ceiling of a nearby
closet).