User's Manual

6
Wireless Extenders
YX500-CEL Installation Guide
Warning: The YX500-CEL base unit MUST only be used with the
provided power adaptor. Attempts to use other power
adaptors will void the warranty and is not FCC approved.
Installation Tools
The following tools are needed to install the YX500-CEL:
• #2 Philips screwdriver
• Cordless drill
• Cellular phone operating in 800 MHz band
Installing the YX500-CEL
Installing the Signal
Antenna
There are four options available for installing the Signal Antenna:
1. Install the Signal Antenna in the attic using the accessories included in the
YX500-CEL kit (an attic installation is not recommended if the outside cell
phone signal test yielded less than 2 signal bars).
2. Install the Signal Antenna outside using the optional Outdoor Installation
and Grounding kit ( Part# YX011 )
3. Install the Signal Antenna outside using parts and accessories that can be
purchased at a home improvement or electronics store.
4. Call 1-800-871-1612 to arrange for a professional installation.
Warning:
Avoid placing antenna near metal such as wiring, A/C ducts, truss
plates, etc.
When attaching the cable to the antenna, run the cable straight
down from the antenna. Avoid draping the coax near the antenna.
Attic Installation of
the Signal Antenna
Once you have confirmed that you have a cell phone signal either outside your
home or inside your attic, you are ready to install the Signal Antenna using the
supplied mounting brackets, Signal Antenna, and coaxial cable.