Specifications

zBoost
®
TRIO Workspace ZB570 Manual
6
Thetotalcablelengthshouldnotexceed65feet.Alongercableishelpfulonlyifitallowsyouto
place the Signal Antenna in a location where you measure stronger signal.
FOURTH: Connect the zBoost Base Unit to the provided power supply and plug
into a power outlet
Upon initial power up, the LED will cycle RED, GREEN and ORANGE for 30 seconds. After 30
seconds,aseriesofGREENasheswillindicatethequalityofyoursetup.Followingthis,asolid
GREEN light indicates normal conditions. If it is not solid GREEN, follow the instructions in the
BaseUnitLEDIndicatorssection.Adjustmentsmaybeneededtooptimizeperformance.Ifyound
the increased signal coverage is acceptable, however, no additional adjustments are needed. See
“zBoost Base Unit Light Indicators” on page 8) for more information.
NOTE: The Base Unit can be plugged into a standard 2 or 3 prong 110 VAC receptacle using the
Included power supply. The power supply consumes less than 10W (less than 0.2A AC). For more
informationonpowerconsumption,see“TechnicalSpecications”onpage9.ConrmThatYour
zBoost is Working Properly
When your zBoost system is in place and fully connected, you should walk throughout the room
and see that you are able to reliably place calls.
Remember, coverage varies based on outdoor signal level, home construction, and antenna
placement.Coverageinadjoiningroomswillbereducedduetowallsorceiling/oors.
Should you desire to improve coverage, you may:
• Move the Base Unit and/or adjust the angle of the Indoor Antenna.
• Move the antenna around the window – higher is usually better.
• Move the Base Unit farther from the Signal Antenna or around a wall.
Improving Your Coverage Area