Specifications

Zaxcom TRX900LT Series Manual Home Screen
5
Main Menu
Frequency – This is the transmit frequency of the TRX-900LT/LTS/LTH/LTHS.
If the transmitter is being used in RECORD ONLY mode “NOTX” will be displayed.
ZaxNet Status
• RX – The transmitter is set to receive ZaxNet timecode and commands.
• TX – The transmitter is sending ZaxNet timecode and audio.
Transport Status - Displays the current mode of the recording feature.
• STOP – Recording / Playback is stopped
• LREC – TRX is recording and LOOP RECORD mode is enabled
• REC – TRX is recording and NON-LOOP RECORD mode is enabled
• WAIT – May appear just before going into record, or if the card is ejected while recording.
Input Audio Meter- Displays the modulation of the inputted audio signal.
In the case of a TRX-900LTS/LTHS if the transmitter is set to STEREO mode you would see both the left
and right audio levels.
Gain - “G” Appears when the transmitter is receiving change of gain commands via ZaxNet.
When in the home screen:
• Press and hold the INC key to display the number of record segments are on the card. Note that
regardless of the size of the card it is limited to 256 segments.
• Press and hold the DEC key to display the current battery voltage
567.4
RX
STOP
ZaxNet Transport
Frequency Status Status
Battery Input Audio Meter Gain
Level Meter Indications
-20, -10, 0 dBFS
G