Specifications

Zaxcom TRX-900LT Series Manual Extended Menu
18
Phase Invert Channel
This will invert the phase of channel 2 (Right) audio to correct for a phasing issue.
This would only be used in if you had a TRX900LTS/LTHS and using stereo mode.
TX Disable
• Record Only Mode – This will set the TRX-900 to act as a standalone recorder and will not transmit any
RF audio on the UHF band.
• Normal TX Mode – This will set the TRX-900 to both transmit RF audio and record on its internal SD card.
Low Battery Stop
This menu sets the amount of time after a low battery warning the on-board recorder will close the current
file and stop recording.
This is to prevent possible file corruption if the unit powers off and on due to a dead battery.
• NEVER STOP - The recorder will not stop recording unless you stop it.
• Any interval from 1 to 99 minutes - once the battery indicator starts blink a low battery warning the
transmitter will continue to record for the time set in the menu - then it will close the file and stop
recording.
Record On Bootup
This menu will determine if the TRX-900 will automatically go into record after the unit boots up.
• ON - The transmitter will automatically start to record after it boots up.
• OFF - The transmitter will wait for a ZaxNet command or a manual record trigger to start recording.
TX DISABLE:
NORMAL TX MODE
PHASE INVER CH2
OFF
LOW BATT STOP:
NEVER STOP
RECORD ON BOOTUP
ON
LOW BATT STOP:
5 MINUTES