Specifications

MAXX OPERATIONS Timecode
44
Timecode Setup
TC Mode
• FREE-RUN – Time code runs continuously.
• REC-RUN – Time code will start to run when Maxx begin to record.
• CJAM – Time code and user-bits are continuously updated from a connected external source.
• CJAM TC – Time code only is continuously updated from a connected source.
• CJAM UB – User-bits only is continuously updated from a connected source.
TC Frame Rate
This sets Maxx’s time code frame-rate.
Maxx supports all standard SMPTE frame-rates:
23.98, 24, 25, 29.97, 29.97DF, 30, 30DF
TC Displayed
This sets what time code that Maxx displays
• GENERATOR – The time code that is displayed is from Maxx’s internal time code generator.
• CARD – Time code is displayed from the file being recorded or played back.
• While in Playback – Time code displayed is the current point in the take.
• While in Record – Time code displayed is the time code being recorded during the take, as it happens.
TC Output
This sets what timecode is sent from the time code output connector. If you need to send running timecode to
another device, set it to Generator. If you want to control another timecode device with an Auto-Load capability, set
it to Card.
• GENERATOR – The time code that is displayed is from Maxx’s internal time code generator.
• CARD – Time code is displayed from the file being recorded or played back.
• While in Playback - Time code displayed is the current point in the take.
• While in Record – Time code displayed is the time code being recorded during the take, as it happens.
Increment UBits
If set to ON the user-bits will increment with each take.
UB Date Style
This is used to set how the date is displayed within the user-bits if you chose to assign the date as the user-bits. You
can choose European or US styles