Specifications

Page 7
IFB Frequency
This is the frequency the ERX’s will receive audio, time code and meta data on.
To adjust the frequency press the INC and DEC arrows to match the frequency your transmitter is set on.
You can choose any frequency form 2.403GHz to 2.475GHz
The signal represents the strength of the ZaxNet signal that the ERX is receiving.
When a valid signal is received, RX is displayed on the right side of the top line.
If you pressing the TIME CODE key while on this page the ERX will cycle through:
• FREQ – signal strength of all antennas are displayed.
• FRONT – Signal strength of only the front antennas are displayed.
• SIDE – Signal strength of only the side antennas are displayed.
Audio Delay
This adjusts the audio output delay in milliseconds.
You can adjust the delay from 5MS to 400MS in 5MS increments.
Software Update
This is used to update the ERX software. When you press the INC key 5 times the ERX will look for
software being transmitted from an IFB100/200 or TRX transmitter.
Group ID
This allows you to set your ERX to a “GROUP” so it can receive audio, time code and meta data via ZaxNet.
So for example a transmitter set to Group 1 will send to all Group 1 receivers and a Group 2 transmitter
will send to all Group 2 receivers. This allows you to control a group of receivers without affecting others.
Group codes can be set from 1 to 99
FREQ: 2.403 RX
SIGNAL: A01 B01
When the ERX is receiving a signal RX will be
displayed.
Signal strength.
Signal strength indicator
AUDIO DELAY:
OFF
PRESS UP 5X TO
UPDATE SOFTWARE
REMOTE CONTROL
GROUP ID =1