Specifications

Page 10
1K Notch Filter Frequency
This menu will only appear if you enable the 1K notch Filter
This allows the ERX to adjust the notch frequency if the tone generator feeding the ERX isn’t exactly
at 1 kHz.
This can be set between 960Hz to 1040Hz in 2Hz steps.
ZaxNet Output Enable - (ERX-TCD Only)
This enables / disables passing Zaxnet commands embedded within the time code output.
Since some time code devices have issues receiving time code with embedded ZaxNet commands, this
feature will allow you to turn off the ZaxNet data that is embedded within the time code. So basically if
you are not sending time code to another Zaxcom device the ZAXNET OUTPUT ENABLE should be
turned OFF.
Time Code Output Level - (ERX-TCD Only)
This allows you to adjust the voltage level of the timecode output for cameras that need different levels.
The options are: .001, .003, .005, .010, .031, .062, .125, .250, .500, 1.000, 2.000, 3.000
VOLUME CONTROL MODE - (ERX-TCD Only)
This will override the ERX volume control knob.
You would likely use this if you have an ERX mounted on a camera feeding audio and you want to avoid an
accidental change to the output level. The two settings are:
• VARIABLE - allows the volume knob to act normally.
• FIXED MAX GAIN - the audio output will be set and locked to the level that was set in the Maximum
Volume menu.
IMPORTANT: When supplying TC to certain Red cameras, you should set this page to 1.0 VOLT.
Individuals have experienced problems with the RED One not being able to reboot while it is receiving too
hot a TC signal.
1K NOTCH FREQ
1000 HZ
ZAXNET OUTPUT
OFF
TC OUTPUT LEVEL:
1.0 VOLTS
VOLUME MODE:
VARIABLE