Specifications

Zaxcom IFB-100 Firmware
16
Firmware
Each unit is shipped with the latest firmware version installed. As newer firmware becomes available,
it can be downloaded from the Zaxcom website:
http://www.zaxcom.com/software-updates
Newer version of Beta software may be found on the Zaxcom Forums:
http://www.zaxcom.com/forum
Each time a unit is powered up, the firmware version number is displayed briefly on the LCD screen.
Pressing the DEC key during the boot up will slow down the screen to allow easier viewing of the
information.
Updating IFB-100 Firmware
1. Download the firmware from the Zaxcom website and load it onto a formatted card.
2. Insert the card into the IFB-100.
3. Simultaneously hold down the INC and DEC keys while powering up the unit.
4. The screen will display “BURN ROM” with the version of firmware you are loading.
5. From power up to “DONE” will take about 30 seconds.
6. Upon completion, cycle the power to run on the new version.
WARNING: Do not power down the unit during the upgrade process. Before upgrading the software be
sure to insert a fresh set of batteries. If the unit should lose power during the upgrade, it will need to be
sent back to Zaxcom for repair.