Specifications

Zaxcom IFB-100 Extended Menu
13
Group Code
This menu allows you to set your IFB-100 to a ZaxNet “GROUP.”
So for example an IFB-100 is set to Group 1 it will control all Group 1 receivers and if set to Group 2 the
IFB-100 will control all Group 2 receivers.
This allows you to control a group of receivers without affecting others. This will also help if two or more
people on set are sending ZaxNet commands each person will be independent and won’t interfere with
each other. Most users leave this set to 1 on all their Zaxcom products.
• Group codes can be set from 1 to 99
Unit Code
This assigns a unit number to the IFB-100. The unit number will tell the IFB-100 to control the unit or units
(if ALL is selected) within a particular group. This number must match the unit code on the TRX transmitter
that you want to control. This allows individual devices in one group to be independently controlled.
You can select ALL or a number from 1 to 200
Minimum Frequency
This menu sets the lowest frequency that you can tune the TRX transmitter to. This eliminates having to
cycle through frequencies that are out of your block.
Maximum Frequency
This menu sets the highest frequency that you can tune the TRX transmitters to. This eliminates having to
cycle through frequencies that are out of your block.
REMOTE CONTROL
GROUP CODE = 1
MIN FREQ: 512.0
(TVCHAN MIN 21)
MAX FREQ: 760.0
(TVCHAN MIN 59)
REMOTE CONTROL
UNIT CODE = ALL