Specifications

Zaxcom IFB-100 Extended Menu

Format Recording Card

This menu will allow you to erase and format the mini SD card.

NOTE: This menu will only appear if a card was inserted prior to booting up. Also if the mini SD card is

removed this page will not appear.

To Format a Card:

1. With the power ‘OFF’, insert the memory card into the media slot with the label to the back of the

unit. Press it all the way in till it “clicks”.

2. Power up the transmitter while holding the Menu key to enter the Extended Menu.

3. Advance to this menu.

4. Press the INC key 5 times.

5. You will see “FORMATTING FAT 32”

6. The TRX will displays “SUCCESS” or “FORMAT FAILED ERROR”

7. If “SUCCESS” appears power cycle the TRX and make sure the unit will record.

Time Code Jam Mode

If record run timecode is being used this menu will control weather the IFB-100 will send record commands

so that the receiving transmitter will automatically go into record when it receives the running timecode.

• AUTO-JAM NORMAL– TheIFB-100 will continuously jam timecode.

• AUTO-LOAD REC RUN – The IFB-100 will continuously jam timecode and will send start and stop record

commands to the corresponding transmitter when it receives record run timecode.

In this mode the transmitter will go into record mode when it detects rolling timecode. And the will stop

when the timecode stops. If timecode is lost because the IFB signal is too weak the unit will continue in

whatever state it was in until the timecode signal is restored.

NOTE: If you see a “FORMAT FAILED ERROR” try to re-format the card and if it fails again DO NOT use

that card in the transmitter.

PRESS UP KEY 5X

TO ERASE CARD

TC JAM MODE:

AUTO-JAM NORMAL