User`s manual

Chapter 3_______________________________________________________Zaxcom Deva User’s Manual
56
Indicator
Description
A
Analog input path, recorder’s pre-amp is assigned
Tx
A
Analog input path, transmitter’s pre-amp is assigned
D
Digital input path, recorder’s input is assigned
Tx
D
Digital input path, transmitter’s pre-amp is assigned
Table 3-5 Indicator Descriptions
Page Level Shortcuts
None
Knob Assign matrix buttons
Pressing it cycles through the available indicators to control which input(s) are assigned to which front panel
fader(s). It is possible to assign one or more inputs to a single fader. It is also possible to assign one input to two
or more faders.
Touch Fader Assign matrix buttons
Pressing it cycles through the available indicators to control which input(s) are assigned to which of the touch
fader(s). It is possible to assign one or more inputs to a single fader. It is also possible to assign one input to two
or more faders.
Preset button
Pressing it allows you to save and recall up to five saved settings. Think of each preset as a page on which to write
the configuration.
To save a configuration, perform the following:
1) Move to the Preset # you want to build. Normally, the first to be built would be Preset 1.
2) If you have not previously saved anything into the preset, it will be a blank slate (pun intended). Establish all of
the required items for this preset.
3) If you need to establish any additional presets, repeat steps 1 & 2 for each additional configuration.
To load a configuration once it has been saved, simply press the Preset button until the number displayed is the
one you’re expecting. At that point, examine the configuration; it will be as you had saved it. If, at any time, you
need to update the configuration, inset your changes, they are automatically saved.
(Analog / Digital) In Toggle button
Pressing it toggles between the analog and digital inputs. You can assign any combination of digital and/or analog
inputs to each fader.
(Fader / ZaxNet Trim) button
Fader – Indicates any change made to the fader affects the Deva’s preamp for this channel.
ZaxNet Trim – Indicates any change made to the fader will send a ZaxNet command to adjust the
transmitter’s preamp associated with this channel.
Clear All button
Pressing it clears all inputs on the page.
Fader Assign Toggle button
Pressing it cycles through several screens within the page to allow all hardware faders and touchscreen faders to
be assigned.