User`s manual

Chapter 3_______________________________________________________Zaxcom Deva User’s Manual
134
About Deva page
Page purpose: This page displays the current hardware and software information, including: currently installed
firmware version, serial number, options installed (Mix-12, EQ, etc.), total number of hours the unit has been
powered up, hardware revision and memory information.
How to get here:
(MENU key  About Deva button)
Deva-16 view Deva-5.8 view
Figure 3-69 About Deva page
Page Notes
On the Options: line, Tracks = is followed by the number of available recording channels.
o If you see EQ, equalization is enabled.
o If you see COMP, compression is enabled.
o If you see UDF, writing UDF files is enabled.
The Serial Number: line is the same as on the Zaxcom sticker located next to the USB connector on the left
side. This number also appears in the Sound report and each audio file. Why? you ask. If you are running 2 or
more recorders on a show and one of them has a problem, this will tell you which unit it was. Also, If your unit
is ever stolen and the files are turned in, Post facilities and personnel can be notified of the theft and be on the
lookout for the serial number.
The Total power on time: line (not shown above) indicates how many hours and minutes the unit has been
running. This value can NOT be reset.
The Hardware Revision: line (not shown above) indicates which version of hardware is installed. *
The Memory used: line (not shown above) indicates how much memory is being used. *
The Largest free block: line (not shown above) displays the size of the largest single block of memory
currently available. *
* You may be asked for this info as part of an error report.
Page Level Shortcuts
None