User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI Main Menu
Main Menu
Entering and Navigating the Main Menu
• Press the MENU key to enter the menu.
• To advance to the next menu press the MENU key.
Exiting the Main Menu
To exit the menu at any time press and hold the MENU key for 1.5 seconds.
Remote Gain Adjust
This menu will only appear if IFB mode is set to TX (transmit)
The remote gain menu adjusts the gain, via ZaxNet, of the TRX transmitter that has the same group and unit
code displayed if “ALL” is selected for the unit code each TRX transmitter in that group will be adjusted
simultaneously. If the TRX is not in range of the ZaxNet signal, the gain command will have to be repeated once
the transmitter comes back into range.
Adjusting the TRX transmitter gain remotely
• Press the INC key to increase the gain. The display will show”++” in the top right hand corner as the gain is
being adjusted.
• Press the DEC key decrease the gain. The display will show”- -” in the top right hand corner as the gain is
being adjusted.
• Each key press will alter the gain by 2dB.
Unit Code Select
Each TRX transmitter can be assigned a specific unit code. That unit code allows for that specific transmitter to
be controlled individually from the PR6BFI. This menu allows for the unit code to be changed so an individual
transmitter can be controlled. If “ALL” is selected multiple transmitters, in the same group, can be adjusted at
the same time. The unit code can be set to any number from 1 to 200 or “ALL” can be selected - to control all
transmitters at the same time.
Please note that if the unit code is changed pressing the MENU key will navigate back to the remote gain menu.
If no changes are made to the unit code pressing the MENU key will advance to the next menu item.
REMOTE GAIN
GROUP 01 UNIT001
REMOTE CONTROL
UNIT CODE = ALL
8