User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI Home Screen
Home Screen
Frequency
Displays the ZaxNet transmit / receive frequency that the PR6BFI is operating on.
Recorder Status
Displays the transport status of the internal audio recorder. When a valid time code signal is being received
this will flash “JAM”. When a formatted card is inserted the approximate record time left on the card will also
flash.
ZaxNet TRX Transport Status
Displays the transmit commands being sent to the transmitters. When in RX mode this will become the status
of the internal recorder.
• REC - TRX record commands will be sent.
• - - - - - Is displayed when the PR6BFI is not sending any commands.
• STOP - TRX recording / playback is stopped.
• PLAY - TRX playback commands will be sent.
Please note that this is the order of the commands as they appear in the PR6BFI. So for example to go from
REC to PLAY the DEC key will need to be presses 3 times and to go from PLAY to STOP the INC key will be
pressed once.
Input Audio Meter
Displays the audio modulation of the inputted signal.
• When the record format is set to MONO one meter will be displayed.
• When in receive mode the meter will display the received audio.
Alternate Home Screen
If the HOME TC DISPLAY menu is set to ON then the frequency will be replaced with the timecode and the
record status is moved to the lower left corner.
Home Screen with time code
2.404
STOP
STOP
ZaxNet Recorder ZaxNet TRX
Frequency Status Status
Input Audio Meter
Meter Indications
-20, -10, 0 dBFS
01:02:34:01 - - - -
STOP I I I
6