User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI PR6BFI Layout
PR6BFI
1. INC Key
• Increases the parameters of a menu item.
• From the home screen will change the transport commands of the corresponding transmitter.
2. LCD Display
3. Menu Key
• Press it to access the menu and to advance to the next menu item.
• Hold while powering up to access the Extended Menu.
4. DEC / Stop Key
• Decreases the parameters of the menu items.
• From the home screen will change the transport commands of the corresponding transmitter.
5. Micro SD Card Slot
To insert a Micro SD card, turn the card so the finger contacts are facing up towards the LCD screen
and down toward the slot. Insert the card into the slot and press it down until you hear a slight click.
To remove it, press the card in until you hear the same click again.
6. Power Switch
7. Antenna Connector - ZaxNet
4