User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI Extended Menu
Encryption Code Set
For normal un-encrypted operations all six numbers should be set to zero. If the encryption code is set to
any number other than all zeroes, the transmitted audio will be encrypted and can only be listened to if
the receiver has the matching encryption code entered. When a receiver is getting an audio signal, and
the codes do not match, all that will be heard is white-noise or silence.
These two sets of numbers are formed into a single six-digit encryption code which provides a total of
16,777,216 possible combinations.
To adjust the encryption code
1. Momentarily press the MENU key to advance to the next character.
2. To change the designated character, press the INC or DEC key.
3. To exit this page, press and hold the MENU key for 1 second.
ID1:000 ID0:000
20