User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI Extended Menu
Maximum Frequency
This menu sets the highest UHF frequency that the PR6BFI will cycle to when remote controlling TRX
transmitters. This eliminates having to cycle through frequencies that are out of the working frequency range
of the TRX transmitters that are being controlled.
Allow IFB Remote Control
This menu will only appear if IFB mode is set to RX (receive)
IFB remote control allows the PR6BFI to receive record commands from another ZaxNet transmitter.
ERX Software Update
This menu is used to update the software on a Zaxcom ERX receiver.
To Update the ERX Software
1. Format a micro SD card in the PR6BFI and with a computer delete the “delete.me” file.
2. Copy the ERX software onto the card and place the card in the PR6BFI.
3. Set up your ERX to receive software (see the ERX manual).
4. Power up the PR6BFI and advance to this menu.
5. Press the INC key.
6. The PR6BFI will begin to transmit the software and will continuously be resent until manually stopped.
Automatic Record On Boot up
Record after boot up will allow the PR6BFI to automatically go into record after it boots up.
• ON - The PR6BFI will automatically start to record after it boots up.
• OFF - The PR6BFI will wait for a manual record trigger to start recording.
RECORD ON BOOTUP
ON
PRESS TO SEND
ERX PROG FILE
MAX FREQ: 698.0
(TVCHAN MIN 51)
ALLOW IFB REMOTE
CONTROL: ON
18