User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI Extended Menu
Mute Time Code Transmission Until Jammed
If mute time code is set to ON the ZaxNet transmitter will not broadcast time code over ZaxNet until it
receives and jams its own internal time code generator. This prevents the ZaxNet from sending incorrect
time code to another device.
Group ID Select
Group ID sets the PR6BFI ZaxNet transmitter to a “GROUP”.
So for example a TRX transmitter set to Group 1 will be controlled by a ZaxNet transmitter set to Group 1 and
a group 2 transmitter will be controlled by a Group 2 ZaxNet transmitter. This allows a group of transmitters to
be controlled without affecting others. This will also help if two or more people on set are sending ZaxNet
commands each person will be independent and won’t interfere with each other. Most users leave this set to
1 on all of their Zaxcom products. Group codes can be set from 1 to 99.
Audio Input Select
The audio input select sets what audio the PR6BFI will input.
•
ANALOG – Used when inputting an analog audio signal.
• DIGITAL L - Used when Inputting a digital signal on pins 1, 2, 3 on the TA5 connector.
• DIGITAL R - Used when inputting a digital signal on pins 1, 4, 5 on the TA5 connector.
Minimum Frequency
This menu sets the lowest UHF frequency that the PR6BFI will cycle to when remote controlling TRX
transmitters. This eliminates having to cycle through frequencies that are out of the working frequency range
of the TRX transmitters that are being controlled.
REMOTE CONTROL
GROUP CODE = 1
INPUT: ANALOG
MIN FREQ: 512.0
(TVCHAN MIN 21)
MUTE TC UNTIL
JAMMED: OFF
17