User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI Extended Menu
SD Card Format
This menu will only appear if a card was inserted prior to booting up
The Micro SD card is erased and formatted from this menu. Please note that all cards need to be formatted
prior to use and only cards formatted in the PR6BFI will work.
Before formatting the card, you may want to name the transmitter– if so please see the transmitter naming
section in this manual.
Formatting an SD Card:
1. With the power off, insert the memory card into the media slot with the card label to the back of the
unit. Press the card all the way in until it “clicks”.
2. Power up the PR6BFI while holding the menu key to enter the extended menu.
3. Advance to this menu.
4. Press the INC key 5 times.
5. FORMATTING FAT 32 will be displayed.
6. In a few minutes, depending on the size of the card either “SUCCESS” or “FORMAT FAILED ERROR” will be
displayed.
7. If “SUCCESS” appears power cycle the PR6BFI.
8. If “FORMAT FAILED ERROR” try to re-format the card, if it fails again it is not advised to use that card.
TC Jam Mode Select
If record run time code is being used this menu controls if the PR6BFI will automatically go into record when it
receives a record run time code.
• AUTO-JAM NORMAL– The PR6BFI will continuously jam time code and will not automatically go into
record.
• AUTO-LOAD REC RUN – The PR6BFI will start and stop recording when receiving record run time code.
In auto-load the PR6BFI will go into record when detecting rolling time code. And will stop when the time
code stops. If time code is lost the unit will not stop but will continue in whatever state it was in until the
time code signal is restored.
Time Code Source
This menu selects how the PR6BFI will receive its time code.
• IFB (RF) – The PR6BFI will receive time code via ZaxNet being broadcast from another ZaxNet transmitter.
• BNC Connector – If BNC is selected and the TIME CODE CONNECTOR menu is set to “INPUT” the
PR6BFI will receive time code via the BNC connector.
TC SOURCE:
BNC CONNECTOR
PRESS UP KEY 5X
TO ERASE CARD
TC JAM MODE:
AUTO-JAM NORMAL
16