User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI Extended Menu
IFB Mode
This menu sets if the PR6BFI will transmit ZaxNet or receive ZaxNet. Please note that is the PR6BFI is set to
receive the TRX transmitter control items in the main menu will not be available.
• OFF - The ZaxNet transceiver is turned off and the PR6BFI will not transmit or receive ZaxNet.
• RX - The PR6BFI will receive ZaxNet IFB audio and time code.
• TX - The PR6BFI will send ZaxNet commands, IFB audio and time code.
IFB Voting Enable
This menu will only appear if IFB mode is set to RX (receive).
This menu enables / disables the IFB Voting function when the PR6BFI is being used to receive ZaxNet.
The purpose of IFB voting is to allow the PR6BFI to choose, and switch to, the stronger signal from two
different ZaxNet transmitters. IFB voting allows a second IFB transmitter to be placed at a different location
then the ZaxNet receiver will choose the stronger of the two signals to listen to.
Please note that when using IFB voting the second ZaxNet transmitting frequency must be set to exactly
2MHz higher than the first ZaxNet transmitter.
ZaxNet Receive Frequency Set
This menu is where the ZaxNet receive frequency of the PR6BFI is set. There are 72 selectable ZaxNet
frequencies from 2.403GHz – 2.473GHz
ZaxNet Transmit Frequency Set
This is where the ZaxNet transmit frequency of the PR6BFI is set. The ZaxNet transmit frequency is the
frequency that the PR6BFI will broadcast remote commands, time code and ZaxNet audio on. There are 72
choices of frequencies from 2.403GHz – 2.473GHz.
IFB MODE: TX
When the PR6BFI is receiving a ZaxNet signal:
ZaxNet receive frequency and RX shows that ZaxNet is being received
ZaxNet signal strength meter
Signal strength
RXFREQ: 2.403
RX
SIGNAL: 28
RXFREQ: 2.403
IFB TX CH: 2.420
IFB VOTING
NORMAL (OFF)
14