User's Manual
Table Of Contents
- PR6BFI
- Home Screen
- Main Menu
- Extended Menu
- Entering and Navigating the Extended Menu
- Exiting the Extended Menu
- 1K Notch Filter
- Record Format
- IFB Transmit Power
- IFB Mode
- IFB Voting Enable
- ZaxNet Receive Frequency Set
- ZaxNet Transmit Frequency Set
- Transmitter Remote Roll Enable
- Power Roll
- IFB Dropout Compensator
- Power-Up Mode
- SD Card Format
- TC Jam Mode Select
- Time Code Source
- Mute Time Code Transmission Until Jammed
- Group ID Select
- Audio Input Select
- Minimum Frequency
- Maximum Frequency
- Allow IFB Remote Control
- ERX Software Update
- Automatic Record On Boot up
- Input Phase Invert
- Home Screen Time Code Display
- Backlight Timer
- Encryption Menu Hide
- Encryption Code Set
- Firmware
- Wiring Diagrams
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom PR6BFI Extended Menu
Extended Menu
Entering and Navigating the Extended Menu
• Press and hold the MENU key while powering up the unit.
• Pressing the MENU key will advance to the next menu item.
Exiting the Extended Menu
• Hold down the MENU key to get back to the extended menu home page then press the INC key.
Or
• Cycle the power
1K Notch Filter
The 1K notch filter is used to eliminate the 1 Kilohertz tone from being outputted to an ERX receiver.
This menu enables/disables the 1 Kilohertz notch filter.
Record Format
This menu adjusts the record format of the internal recorder. Please note that any changes to the record format
will require the PR6BFI to be rebooted.
• US MONO - The PR6BFI will record both inputs summed to mono.
• STEREO -The PR6BFI will record both inputs independently.
• US MONO-R -This setting is not applicable on the IFB-200
IFB Transmit Power
This menu will only appear if IFB mode is set to TX (transmit)
The IFB transmit power of the PR6BFI ZaxNet transmitter is set from this menu.
1K NOTCH FILTER
OFF
RECORD FORMAT:
STEREO
IFB TX POWER: 5
13