User manual

F5100 / F5105 / F5110 / F5115 User Manual
9.4.2 Alarm Sending
Set to send the command with connection to the alarm detection by the external sensor input
or by the built-in motion detection function. Select “On“ to send the command to HTTP
server linked with the alarm detection.
Alarm sending: Select On to set to send command with connection to the alarm detection.
Alarm
Motion Detection: Click it on for using Motion Detection function as a sensor. You
can set motion detection function at the motion detection function screen.
Note: You can set motion detection at motion detection screen. (Please go “Setting
Advanced Motion detection Setting”) For more details, you can check Chapter 9.9.
66
Parameter: the parameter of CGI (defined in URL of HTTP General) is
from your target device. For example, move=down.
Message: message will show up in the form of Message = PTZ down. If your
target device didn’t support the parameter of message, you can’t see the
message. So you can just take the message as a note. For example: PTZ
down.
Setting-Advanced
HTTP Event