User manual

F5100 / F5105 / F5110 / F5115 User Manual

Note: If you use g-mail as your mail server, you should set 25 as your port number and

tick SSL box.

 Authentication: Select the authentication required when you send an email.

Off: Select if no authentication is necessary when an email is sent.

 On: When authentication is necessary an e-mail is sent, select one of the

authentication methods from the followings.

 SMTP: Select if SMTP authentication is necessary when an e-mail is sent.

 POP before SMTP: Select when POP before SMTP authentication is necessary when an

e-mail is sent.

Note：When you set to On, be sure to select either or both SMTP or / and POP before SMTP.

 POP server name: It is necessary when the POP before SMTP is selected in

Authentication. Type the POP (receiving mail) server name up to 64 characters, or

type the IP address of the POP server. This setting is necessary when the SMTP server

which sends e-mails performs authentication using the POP user account.

 User name, Password: Type the user name and Password of the user who has the

mail account. This setting is necessary when the SMTP server which sends e-mails

performs authentication.

 Recipient Ee-mail Address: Type the recipient e-Mail address up to 64 characters. You

can specify up to three recipient E-mail addresses.

 Administrator E-mail Address: Type the Administrator e-Mail address up to 64

characters. This address is used for reply mail and sending system messages from the

SMTP server.

 Attached File Type: You can choose snapshot or video clip for alarm sending. Select

“Snapshot,” one snapshot will be transmitted to the administrator’s e-mail address while

motion detection / audio detection / alarm input triggered. Select “Video Clip,” one

5-seconds video clip will be transmitted.

 Subject: Type the subject/title of the e-Mail up to 64 characters. With respect to mail

which is sent according to the alarm detection when Alarm sending of the alarm tab is set

to On, the characters standing for the sensor type added to the subject.

 Message: Type the text of the E-mail up to 384 characters. (A line break is equivalent to 2

characters.)

 Test: After setting the SMPT server information, you can tick the test key to test if the

connection between IP CAM and the SMPT server works.

Setting-Advanced

SMTP