User manual

P5110 / P5115 User Manual

9.8 Alarm Output

You can set Alarm Output function in this menu to control the alarm out of I / O port on the

rear of the device linked to the alarm detection and the timer.

 Alarm Output: To activate the Alarm output function, select On. If not, select Off.

 Digital Output: Select High signal output and Low signal output as your alarm.

 Trigger Condition: Select the mode of the Alarm output function. You can choose

“Alarm” or “Timer”.

 Alarm: Controls alarm output by synchronizing with an external sensor input or the built-in

activity detection function.

 Motion Detection: Click it on for using Motion Detection function as a sensor. You

can set motion detection function at the motion detection function screen.

Note: You can set motion detection at motion detection screen. (Please go “Setting →

Advanced → Motion Detection → Setting”) For more details, you can check Chapter 9.12.

 Audio detection: Click it on for using Audio Detection function as a sensor. You can

set audio detection function at the audio detection function screen.

Note: You can set audio detection at audio detection screen. (Please go “Setting →

Advanced →Audio Detection → Setting”) For more details, you can check Chapter 9.13.

 Use Alarm Buffer: Click it on to use alarm buffer function for recording audio and

video file before and after disconnected network.

Note: You can set alarm buffer at alarm buffer screen. (Please go “Setting → Advanced

→ Alarm Buffer → Setting”) For more details, you can check Chapter 9.11.

Setting-Advanced

Alarm Output