Instruction Manual

9
the magazine well. With the lugs engaged you
should be able to swing the magazine up into
the locked position. To remove the magazine
push the magazine release lever forward and
swing the magazine down while pushing the
magazine release lever. SEE FIG 26
Upper Receiver Release Latch: Located in
back of receiver above stock. If the detente is
depressed and the latch is depressed, the
upper receiver dust cover can be removed for
disassembly. See disassembly section of
manual. SEE FIG 29
Upper Receiver Release Latch Detente:
Located on back left side of receiver. Round
button that must first be depressed before latch
is depressed. SEE FIG 28
Bolt Catch : To use the Bolt Catch move the
safety to the off position and pull the bolt to
the rear and then push the Bolt Catch up so
that it engages the bolt and holds it in the rear
position. Now release the bolt and it should
be held in place by the Bolt Catch. Thus, to
load a gun with a Bolt Catch simply lock the
bolt back as directed above, insert magazine
as directed above. Then pull the bolt handle
to the rear and release and the bolt handle and
the bolt will strip a round from the magazine.
Immediately move bolt block safety to the safe
position after a round has been stripped from
the magazine. SEE FIG 23 & 24
Directions for Assembly
The PAP comes fully assembled. All you will
need to do is remove the wrapping, clean the
protective oil from the gun and insert the
magazine.
To load your Firearm
1. Make sure the firearm is pointed in a safe
direction at all times, the safety is engaged,
and never allow fingers or objects to contact
trigger.
26.
29.
28.
23.
24.