Instruction Manual

21.

BEEN REMOVED. SUCH TECHNIQUE(S) CAN GENERATE EXCESSIVE

PRESSURE, DAMAGE THE FIREARM AND CAUSE SERIOUS PERSONAL

INJURY. If the blockage can be removed with a cleaning rod, clean any

unburned powder grains from the bore, chambers & mechanism before

resuming shooting. If the blockage can not be dislodged by tapping it with a

cleaning rod, take the firearm to a gunsmith.

WARNING (Mechanical Malfunctions)

STOP SHOOTING IMMEDIATELY AND UNLOAD YOUR FIREARM if your firearm

develops: a mechanical malfunction; binding or stoppage; spitting powder/

gas; a cartridge primer is punctured; a cartridge case is bulged or ruptured;

or the sound on firing does not sound quite

right. Do NOT try one more shot but unload

your firearm and take it and the ammunition to

a qualified gunsmith or send it back to EAA for

examination. Do not assume that the firearm

is empty merely because you checked the

chamber. You must also check the bore for

any fired shot or wad jammed inside the barrel.

External Control Parts:

Bolt Block Safety: Located on receiver above

trigger, pivot slide style. When moved to the

full up position blocks bolt movement, covers

bolt and blocks trigger movement. When in the

lower position bolt is fully exposed and free to

move and the firearm will fire if trigger is

pulled!! Do not disengage safety unless you

are ready to fire the firearm. (Safety Engaged -

Bolt Covered and Blocked and the trigger is

blocked from full travel; Safety Disengaged -

Bolt is fully exposed and the trigger has full

travel...MAKE SURE YOU UNDERSTAND HOW

THE SAFETY WORKS BEFORE YOU LOAD OR

USE THE FIREARM) SEE FIG 21 & 22

Trigger: Located in the trigger guard with

safety disengaged and trigger pulled to the

rear the firearm will discharge. SEE FIG 27

Bolt Cocking Handle: Located on right hand

side of the firearm protrudes from bolt used

for pulling bolt rearward. SEE FIG 25

Magazine Release Lever: Used for insertion

or removal of the magazine. To insert the

magazine engage the front lug of the magazine

with the magazine lug located in the front of

22.

27.

25.