Instruction Manual

2. Using the bore brush with powder solvent scrub the barrel and chamber to

remove any powder and lead residue in the bore. Always and lastly, swab

with cotton patch with gun oil to coat and protect the bore and chambers

from rust and corrosion.

3. Any powder fowling on the firing wall, barrel, etc. can be easily cleaned

with a brush and powder solvent.

5. All external surfaces should be wiped down with light coat of rust

preventative. Avoid using too much oil as dust and/or debris can get trapped

in the oil creating a gum that in time will cause misfires.

6. CAUTION in using solvents in gun bore cleaning. Prolonged or excess

contact with finish or bluing can damage the gun’s finish. Be sure to wipe

away all excess solvent and then lubricate with oil.

7. A gun should be cleaned after firing. In addition, external parts should be

wiped with an oiled cloth after handling. A light oil is ordinarily all that is

necessary in cleaning if the gun has not been fired or fired very little. If a gun

is used frequently, it must be cleaned after each firing and regularly serviced

by a professional gunsmith. If the gun has been stored, remove all excess oil

and/or grease before firing. Always check to be sure that no cleaning patch

or other obstruction remains in the bore or chambers before firing.

DANGER — AMMUNITION WARNING

Firearms may be damaged and serious injury or death to the shooter or

bystander may result from any condition which contributes to the generation

of excessive pressure or uncontrolled release of gas within the firearm. Such

adverse conditions can be caused by bore or chamber obstruction, propellant

powder overloads or by defective, incorrect or improperly loaded and assembled

cartridge components. Even the strongest firearm can be blown up as a result

of excessive pressure. It is extremely dangerous to use a cartridge whose pressure

is greater than that developed by cartridges loaded to industry standards.

AMMUNITION NOTICE

We specifically disclaim responsibility for any damage, injury or death

occurring in connection with or as the result of the use of European American

Armory Corp. firearms of faulty, nonstandard, remanufactured, hand loaded

or reloaded ammunition, used cartridges or cartridges other than factory

cartridges for which the firearm was originally chambered.

LUBRICATION WARNING

Firing a firearm with oil, grease or any other material even partially obstructing

the bore may result in damage to the firearm and injury to the shooter and

those nearby. Do not spray or apply lubricants directly on ammunition. If the

powder charge of a cartridge is affected by the lubricant, it may not be ignited,

but the energy from the primer may be sufficient to push the bullet into the