Instruction Manual

13
Fig 2: Depress the Upper Receiver Release
Latch button and then depress the latch
Fig 3: Grasp the dust shroud and pull it away
from the receiver body, now the internal
mechanism of the firearm is exposed
Fig 4: Push the Upper Receiver Latch forward
with your thumb and index finger controlling
the latch. Push the latch far enough forward
so that it is free of the latch rails and lift up and
remove the latch assembly from the receiver...
Be careful because the latch is under spring
tension.
Fig 5: Disengage safety and then pull bolt
assembly to the rear and remove from receiver.
Fig. 6: Separate the bolt from the bolt support,
to do this move the bolt backward, give it half a
turn counter-clockwise and take it out by using
a forward motion.
To reassemble start with reinstalling bolt
assembly and work your way backward
through the steps of assembly.
Fig. 13: On the “PAP” rifle turn the gas tube
cotter pin upwards with the aid of an empty case
or screw driver, detach the gas tube using an
upward motion.
CLEANING AND MAINTENANCE OF
THE FIREARM
A) Follow procedures for unloading the firearm
as described previously
B) Follow procedures for disassembly of the
firearm as described previously
1. Materials needed to clean this firearm are: a
cleaning rod, cotton bore patches, brass bore
brush, powder solvent, a small soft brush and
good quality gun oil.
WARNING: Lead or lead compounds are
known to the State of California to cause
cancer, birth defects, reproductive toxicity, and
other serious physical injury. Those who clean
firearms should take protective measures to
avoid contact or exposure to such chemicals.
3.
4.
5.
6.
13.