Instruction Manual

12
2. Fig 12: Remove the magazine by pushing
the magazine release lever forward until it
touches the body of the magazine, while
keeping the release lever in the forward
position swing the magazine forward and out
of the receiver.
3. Fig 13aa: With the magazine removed move
the bolt block safety to it’s lower position, slide
the bolt to the rearward position via the cocking
handle and inspect the chamber to be certain
the firearm is empty and free of debris and then
re-engage the safety so that it is holding the
bolt in the rearward position. If there was a
spent or unspent cartridge in the chamber it
should of been ejected. If there is a cartridge
stuck in the chamber and it did not come out
when you moved the bolt to the rear, obtain a
cleaning rod and push the cartridge out
backward.
MANUFACTURER’S WARNING
This firearm was manufactured to properly perform with the original parts as
designed. It is your duty to make sure any parts you buy are correctly installed
and that neither replacements nor originals are altered or changed. Your gun
is a complex tool with many parts that must relate correctly to other parts for
safe and accurate operation. Putting a gun together wrong or with modified
parts can result in a damaged gun, injury or death to you or others through
malfunction. Always let a qualified gunsmith
work on your gun or at least, check any work
not performed by a gunsmith. Firearms safety
is your primary concern. THE GUN OWNER
MUST ACCEPT FULL RESPONSIBILITY
FOR THE CORRECT REASSEMBLY AND
FUNCTIONING OF THE FIREARM AFTER
ANY DISASSEMBLY OR REPLACEMENT OF
PARTS.
Direction for Disassembly for
Cleaning and Maintenance and
Reassembly
Make sure the gun is unloaded and pointed in
a safe direction. Make sure the safety is on.
There is no excuse for not being careful.
Fig 1: With the bolt in the forward position
and the safety engaged
12.
13aa.
1.
2.