Instruction Manual

10
2. Do not load firearm until you are ready to
fire.
3. Remove magazine if it is not already
removed
4. Do not disengage the safety.
5. Make sure the ammo that you are using is
the correct caliber. The receiver or barrel is
marked with the caliber.
6. Fig 30 Visually inspect the chamber for
obstructions by moving the bolt back and
looking into the chamber. The chamber should
be free of oil or grease or obstructions... The
chamber is the rear portion of the barrel where
the cartridge slides into from the pressure
applied by the bolt.
7. Fig 9: After determining there are no
obstructions in the chamber release the bolt
and move the bolt block safety up or in the
safe position, so that it blocks the movement
of the bolt.
8. Fig 7: For rifles, insert ten or less cartridges
into the magazine.
**WARNING**
Never insert the magazine into the receiver until
you are ready to fire the firearm...
9. FIG 8: With the bolt in the forward position
and the bolt block safety in the safe position
you may now insert the magazine as described
in the previous section.
To Fire Your Firearm
**WARNINGS**
• Do not disengage the safety until the firearm is pointed in a safe direction
and you are ready to fire.
• If a cartridge does not fire and the trigger has been pulled and the safety is
disengaged... Stop! And do the following: a) Make sure the gun is pointed in
a safe direction b) Engage the safety c) Wait 60 seconds d) Follow the instruc-
tion below for unloading the firearm.
• Semi auto firearms automatically feed the next live round from the maga-
zine into the chamber each time the gun fires. No user intervention is required
30.
9.
7.
8.