Manual

PAP M92 & M85 Pistol Manual
© 2012 Century International Arms, Inc.
Page 9
WARNING! Always unload your pistol immediately after use and prior to
cleaning and storage to minimize the risk of an accidental discharge. If your pistol
ever fails to fire keep it pointed at the target for at least 30 seconds in the event of
a hangfire (slow ignition). If the round still does not fire, remove the magazine, eject
and discard the bad round. Reload the pistol to resume firing.
Unloading the Pistol
WARNING!
Keep muzzle pointed in a safe direction.
1. Move the safety lever to the "SAFE" position. (See Illustration #7.)
2. Remove the magazine. To remove the magazine from the pistol while holding the
pistol in the firing position, simply slide your left hand from the lower handguard to the magazine.
Grasp the magazine and press the magazine release lever with your thumb. (See Illustration #12.)
You will now be able to rotate the bottom of the magazine toward the muzzle end of the pistol
and remove it from the magazine well in the receiver. (See Illustration #13.)
3. Place your trigger finger inside the triggerguard and on the trigger.
4. After aligning the sights, slowly pull the trigger to fire the first round.
5. Being a semi-automatic pistol, the pistol's action (its moving parts) will cycle after the first
round is fired. As the bolt moves rearward, the extractor will pull the empty cartridge case
from the chamber and eject it from the pistol. (Make sure there are no bystanders in close
proximity on either side of the pistol who could be injured by the ejected cartridge case or
gasses expelled from the pistol.)
Note: If the trigger is pressed again, the pistol will fire! Keep the pistol
pointed in a safe direction.
6. Firing may be continued in this manner until the magazine is empty.
7. When firing is finished, place the safety lever in the “SAFE” position.
8. Remove the magazine from the pistol. See section on unloading the pistol below.
9. Check the pistol's chamber to ensure it does not contain a round by placing the safety lever in
the "FIRE" position, pulling the bolt cocking handle back and then looking into the chamber
through the ejection port while keeping the pistol pointed in a safe direction. When you are
finished checking the chamber, release the bolt cocking handle and return the safety lever to
the "SAFE" position.
Illustration #12
Press the magazine release lever forward to
remove the magazine from the pistol.
Magazine release lever
Illustration #13
3. Move the safety lever to the “FIRE” position and check the pistol's chamber to ensure it does
not contain a round. (See Illustration #8.)