Manual

Bolt Catch: To use the
bolt catch, move the safety
lever to the “FIRE” position
and pull the bolt to the rear
and then push the safety
lever up to the "SAFE"
position so that it engages
the bolt and holds it in the
rear position. Release the bolt
and it should be held in place
by the safety lever. (See Illustrations #5 - #6.)
Safety lever in lower or “FIRE” position. Pulling
the trigger when the safety lever is in the lower
position will result in the pistol firing if there is a
round in the chamber! Exercise extreme caution
when handling pistol in this condition.
Illustration #7
Safety lever in upper “SAFE” position.
Illustration #8
PAP M92 & M85 Pistol Manual
© 2012 Century International Arms, Inc.
Page 7
1. Place the safety lever in the “SAFE” position. The safety lever is in the “SAFE” position when it
is moved to its uppermost (top) position on the receiver. You should hear an audible “click”
when it is correctly in place. (See Illustration #7.)N OTE: When the safety lever is in its lower
position on the receiver, the safety lever is in the “FIRE” position. (See Illustration #8.)
To Load the Pistol
WARNING! Before loading, make sure the inside of the barrel is free of dirt or
other obstructions.
WARNING! Always check each cartridge to ensure it is of the correct caliber
before loading the firearm.
WARNING! Never load a firearm indoors. An accidental discharge will cause
property damage, serious injury and/or death! Never use live ammunition to
function test your pistol indoors.
WARNING! Keep fingers away from the trigger while loading.
WARNING! Keep muzzle pointed in a safe direction.
WARNING! The safety lever should not extend below the safety lever stop on
the bottom of the receiver or rise past the receiver cover. If it does, put the lever in
the safe position by rotating it either up or down into the safe position. If this
occurs, have the pistol inspected by a competent gunsmith before further use.
Illustration #5
“FIRE” position.
“SAFE” position.
Illustration #6