Manual

PAP M92 & M85 Pistol Manual

Page 11

6. Remove the bolt carrier and bolt from the pistol by holding the receiver with your left hand

and the cocking handle with your right hand. Pull the bolt carrier and bolt to the rear as far as

possible. Once the back of the bolt carrier contacts the back plate of the receiver, release

pressure on the bolt cocking handle, this will allow the bolt carrier to move up and off the

receiver rails. Lift the rear portion of the bolt carrier and remove it and the bolt from the

receiver. (See Illustration #16.)

7. Remove the bolt from the bolt carrier by turning the bolt carrier over and holding it in your

left hand. (See Illustration #17.) Rotate what is now the top of the bolt to the right and move

it rearward with your right hand so that the guide lug on the bolt leaves the channel in the bolt

carrier. You can now remove the bolt from the bolt carrier by moving it forward and out of its

guide hole.

Illustration #16

Illustration #17

Reassembly

1. Attach the gas tube assembly and upper handguard by holding the pistol by the forward

portion of the receiver with your left hand, and with your right hand install the front end of the

gas tube on the gas block. Align the gas tube end with its groove in the rear sight base and

rotate it downward until it is fully seated in the rear sight base. When the gas tube assembly is

fully seated in the rear sight base, the gas tube securing pin will move out and over the gas tube

to lock it in place.

2. Install the bolt back in the bolt carrier by first holding the

bolt carrier upside down in your left hand with the

gas piston facing away from you. Then take the bolt

in your right hand with the bolt face facing away

from you and the guide lug facing upward. Insert the

bolt shaft into the guide hole on the bolt carrier

and bring the bolt fully rearward. Align the bolt

guide lug with the channel in the bolt carrier and

rotate the bolt to the left. Once the guide lug has

entered the channel in the bolt carrier continue to

rotate until the bolt has moved forward as far as

possible. (See Illustration #19.)

Illustration #19

8. Remove the gas tube assembly and upper

handguard from the pistol by holding the

forward portion of the receiver with your left

hand and pressing in the gas tube securing pin.

(See Illustration #18.) Then, lift the gas tube end

vertically out of its groove in the rear sight base

and remove the front end of the gas tube from

the gas block.

Illustration #18