Manual

DESCRIPTION, HANDLING AND MAINTENANCE

FUNCTION OF THE PISTOL

The hammer is cocked by pulling the slide back-

wards. By releasing the slide to the front position,

a cartridge is taken from the magazine and put into

the barrel. The pistol is loaded and ready to re.

To trigger and re the cartridge, the trigger is pulled

backwards, which releases the hammer. Under the

eect of its spring, the hammer moves forward,

strikes the ring pin, which strikes the primer of the

cartridge and the ring is done. After the cartridge

is red, under the eect of powder gas, the bullet

comes out of the barrel and the slide moves back-

wards, the cartridge case is extracted and ejected.

At the same time, the hammer is being cocked.

Under the eect of recoil spring, the slide moves

forward and brings a cartridge into the barrel.

To re the next cartridge it is necessary to pull the

trigger and further process is done as previously ex-

plained.

When the last cartridge is red, the coupling (A) is

lifted and its lug comes into the notch on the slide.

The slide is kept in rear position (Fig. 2).

To continue shooting, it is necessary to replace the

empty magazine with a loaded one. To take out the

magazine, it is necessary to press the magazine re-

lease button (B) and take the magazine out (Fig. 2).

When a loaded magazine is put into the pistol, the

coupling (A) is pushed downwards. In that way, the

Fig. 2> Slide in rear position (A) – coupling, (B) – magazine release

button