Service manual

137
137
- Parameter setting variables -
The following table shows the different values at which the parameters can be set.
(*) The acceleration time shown is the
time from 0 Hz to 100 Hz. This is the
ideal ramp calculated by the software;
the real ramp could change as a
function of motor control parameter
setting and, obviously, as a function
of the load.
(**) The braking feature is based
upon deceleration ramps. The value
shown in the table is the time to
decrease the speed from 100 Hz to 0
Hz. This is the ideal ramps calculated
by the software; the real ramp could
change as a function of motor control
parameter setting and, obviously,
as a function of the load.