Service manual

107
107
- 15/18/20BT-7, 16/18/20B-7 Pump (05) Parameter setup.
PARAMETER CHANGE
DESCRIPTION
(Service level)
E mode N mode
H mode
0
ACCELER. DELAY
Determines the pump acceleration ramp-up. It's adjustable between 0 and 100Hz.
5
DECELER. DELAY Determines the pump deceleration ramp. It's adjustable between 0 and 100Hz.
246
MAX SPEED UP 81 92 108
Maximum pump speed during lift function.
245
MIN SPEED UP
Minimum pump speed during lift function after lifting enable switch is closed.
20
CUTBACK SPEED
It determines max. lift speed when the speed reduction cutback switch is (open) E13.
242
TILT SPEED
Tilt function speed, fine regulation.
243
SHIFT SPEED
Shift function speed, fine regulation.
244
AUX SPEED
Auxiliary function speed, fine regulation.
48
HYD SPEED FINE
Hydro speed, fine regulation.
63
MAXIMUM CURRENT
The maximum current of the inverter.
56
IDLE TIME
Time delay when an hydraulic steering function request is switched off. (Steering del.)
CODE
SET MODEL
(Service level)
Parameter explanation.
CONNECTED TO
Code 5 = Connected with pump controller (selection which controller you want to con.)
CODE
SET OPTIONS
(Service level)
Parameter explanation.
125 HOUR COUNTER
RUNNING: the counter registers travel time only.
KEY ON: the counter registers when the "key" switch is closed.
141 SET TEMPERATURE
DIGITAL: a digital (ON/OFF) motor thermal sensor is connected to F6 input.
ANALOG: an analog motor thermal sensor is connected between F6and F12
NONE: no motor thermal sensor switch is connected.
250 JOYSTICK
OFF: Truck with mechanical lever distributor. (std).
ON: Truck with electro-hydraulic distributor. (Finger Tips)
249 DIGITAL LIFT
OFF: The lift speed is changed proportionally with the lift sensor analog input status.
ON: The lift speed is determined only by the lift digital input. When the input is closed
the pump run at full lift speed programmed.
Values
Values
Parameter explanation.
CODE
100%
ANALOG
OFF
OFF
81
18.00
KEY ON
16
LEVEL = 9
1.9
48V (Europe)
5
LEVEL = 0
LEVEL = 0
30
30
(Hydraulic Steering)