Service manual

103
103
- 15/18/20BT-7, 16/18/20B-7 Traction Master (03) setup.
Code
SET MODEL
(service level)
CONNECTED TO
Code
SET OPTIONS
(Service level)
125 HOUR COUNTER
121 BATTERY CHECK
245 TRACTION CUTOUT
244 LIFT CUTOUT
246 S. R. O.
251 HYDRO KEY ON
ON
ON
ON
ON
KEY ON
Values
OFF
ON : if this option is programmed "ON" the traction inverter
manages an external hydraulic steering function when the "key" is switched ON.
ON: the battery discharge level check is carried out; when the battery level reaches 10% the traction
maximum current is reduced to the half of the programmed value. Traction speed/current is also reduced
(optional) and lift function is disabled(optional). At key on if battery is below 10% lift function is allowed
for 10-20 seconds
OFF: the battery discharge level check is carried out but no alarm is signalled.
ON : when the “Battery low” alarm appears, and this option is programmed "ON", the traction speed is
reduced to 60 Hz.
ON : When the “Battery low” alarm appears, and this option is programmed "ON" the lift function is
disabled.
When S.R.O. option is set to "OFF" allowed sequences are:
Key -> direction lever -> pedal
Key-> pedal -> direction lever within the SEQUENCE DELAY TIME.
No sequence is requested on the seat switch.
When S.R.O. option is set to "ON" allowed sequences are:
Key -> seat -> direction lever -> pedal
seat -> key -> direction lever -> pedal
Key-> seat -> pedal -> direction lever within the SEQUENCE DELAY TIME.
seat -> Key-> pedal -> direction lever within the SEQUENCE DELAY TIME.
The SEQUENCE DELAY TIME is adjustable.
When pedal or direction levels are active at key on traction shows INCORRECT START.
When incorrect sequence is detected traction shows SEQUENCE FAULT.
Parameter explanation.
RUNNING: the counter registers travel time only. KEY ON: the counter registers when the "key" switch is
closed.
Parameter explanation.
Values
Code 3 = Connected with Master controller (selection which controller you want to con.)
3
OFF
OFF