Owner manual
ST-2X Output
3
6
5
4
2
1
1. LED Indicators let you know the status of the amplier. The green LED
tells you the amp is on. The Red LED lets you know the amp is in
“protecon” because of some problem with the system.
2. Fuse The fuse protects the car should a catastrophic problem occur in the
amp. Always replace with the same size fuse
3. Speaker connecons The heavy duty terminal block provides posive
speaker connecons. Simple insert the wire and cinch down the set
screw. Note that the Mono bridge posions here are L - to R +
4. GND The amp should have a rm connecon the car frame. * See sec-
on "Install Sense"
5. REM The remote terminal connects to the head unit remote out, or to
some other switched 12 volt source to turn on the amplier.
6. +12V The main 12 volt must be connected directly to the vehicle’s baery
using wire of the proper gauge. * See secon "Install Sense"
-
+