Instruction Manual

9. Install the OMAP board, taking care about the direction.
10. Tighten the screws for DAC boards and OUTPUT boards, after screws are tightened please use force to
press boards to make sure that they are inserted into sockets well, if screws do not thread easily then the
boards are likely not in correctly and should be rechecked.
11. Tighten screws of the bottom panel. Put back the top under cover and tighten the screws.
Notes: Pay attention the direction /position of OMAP module. If the screws can’t be tighten that means DAC
or OUTPUT boards are not in the right position. The length of the wires can be adjusted for a better installation.