User's Manual
3. Attach Gas Source: Attach gas source according to manufacturer of
propellant cylinder’s instructions.
4. Load Paintballs: Attach hopper (not included) according to manufacturer
of hopper’s instructions and fill with paintballs. Do not fill to the point that
paintballs are packed tightly together inside hopper. *Note – Paintballs
should be stored in a cool, dry place in a sealed bag or container. Do Not
subject paintballs to freezing, excessive heat, humidity or store in direct
sunlight.
5. Eye Protection: Make sure that everyone within range is wearing eye
protection designed specifically for paintball.
6. Remove Barrel Blocking Device and press actuation button to take off
safe and set marker to “fire” mode. LED will glow green to indicate ready
to discharge.
7. Verify Velocity: Make sure that the paintball marker’s velocity is below
that required by playing field operator. The velocity must be set below 300
feet per second regardless of planned location for usage.
8. The paintball marker is now ready to discharge.
Adjusting the Sear
After some use, the sear may require adjustment, as the distance between
the striker and sear may change.
Step 1 – Loosen adjustment locking screw (3)
Step 2 – Unscrew sear adjustment screw until flush with trigger frame
body.
Step 3 – Turn on trigger frame on (no air attached) set to fire mode.
Step 4 – Pull bolt to back position, cocking marker.
Step 5 – Pull trigger. If bolt releases re-cock and repeat step 5 at least 4
times. If marker fires correctly, attach air and repeat step 5. If marker
again fires correctly, tighten adjustment-locking screw. Adjustment is
complete. If marker does not fire, see step 6.
Step 6
– If marker does not fire, tighten sear adjustment screw 1/8
th
turn.
Repeat step 5. Repeat step 5 until marker fires correctly. Remember to
tighten adjustment locking screw (3).
Trouble Shooting Guide
Problem Cause Cure
Gas Leak Seal Failure (location of leak) Replace
A - Out of the Barrel Cup Seal/Valve O-Ring
B - Out of Foregrip Foregrip O-Ring
C - Out of Volumnizer Volumnizer O-Ring
D - Out of Regulator Propellant Source O-Ring
Marker will not cycle A - Marker Not Cocked Cock Marker