User's Manual

Introduction
Introducing the new Amp with LCD, electronic safety, battery level
indicator, semi-automatic with game timer, shot counter, high impact panels and
double trigger with up to 20 balls per second cycle capability. What sets this
marker apart from the rest is its revolutionary, external adjustable solenoid and
sear.
Operation of the AMP LCD
The Amp is powered by a 9-volt battery (not included). To install the
battery, remove front trigger frame panel (see Fig. 1-1) and plug in and insert
battery as shown. Secure panel with screws.
TO TURN ON PRESS AND HOLD F-1 FOR 4 SEC
IN ALL MODES PRESS F-2 FOR 4 SEC (SAFETY IS ON)
PRESS F-1 TO CHANGE MODES
IN SEMI MODES PRESS F-2 FOR RATE OF FIRE (4-20)
PRESS F-1 TO SET
IN COUNTER MODES PRESS F-2 + F-2 TO RESET
PRESS F-1 TO SET
IN TIMER MODES PRESS F-2 + F-2 TO SET TIME
PRESS F-1 TO SET
IN POWER MODE F-2 + F-2 TO CHANGE TO NORMAL MODE
PRESS F-1 TO SET
*AUTO POWER – OFF POWER SAVING MODE WILL TURN OFF THE
POWER TO YOUR TRIGGER FRAME AFTER 30 MINUTES (ONLY IF
MARKER HAS NOT BEEN FIRED WITHIN 30 MINUTES, THE 30 MINUTES
COUNTDOWN WILL RESET EVERY TIME MARKER IS FIRED) THIS
FUNCTION WILL ALLOW THE MARKER TO TURN OFF THE POWER
AUTOMATICALLY IF NOT USED AFTER 30 MINUTES.
Operating Instructions
1. Make sure barrel blocking device is in place. Turn on Marker and Put on
“Safe” by pressing actuation button and releasing. The button will glow
red indicating “safe”.
2. Cock: Cock marker by pulling cocking handle back fully until locked in
sear position. This is a semi-automatic marker which will re-cock itself
after each discharge when working correctly.