User Manual

Step 1
Turning the center stem #2 upside down fix the base plate #onto
the stem using the M 6x40 screws as shown in graph 1.
Step 2
put the Monitor Stand upright and using M 6x30 screws fix part#
onto the extractable center slide on part#
Graph 1
MATERIALS USED
- solid wood (ash or oak) and particle board
- iron adjustment mechanism
PACKING LIST
- 3 wooden parts
screws
- 4 screws M 6 x 30

INSTRUCTIONS FOR CLEANING
- use a humid cloth or special wood cleaner
- avoid using abrasive cleaners
PRODUCT CAN BE ASSEMBLED BY ONE PERSON
Attention !!!
It is very important that, after finishing installation and setting up the desired height of the Monitor
Stand, you fasten the mechanismby turning the knob clockwise without forcing. This will take several
turns. When the knob sits tight against the base, your stand is secured. Now you can place your speaker
or other device on top of the stand. To change height, please turn counter-clockwise several full 
turns until you are able to retract the knob from the hole: CAREFUL: Do not attempt to do this while
your speaker(s) are sitting on top of the stand! Remove your speaker(s) from the stand to adjust
height. When you have found your new height, make sure to turn the knob clockwise once again, to
fasten it, like described above.
2
3
2
1