Miza 88 XL
Thank you for choosing a piece of Zaor studio furniture, which will hopefully make your life easier, more ergonomic and improve the looks of your workspace. Before you can enjoy the comfort of your new acquisition you need to assemble it. We have tried to give you as much detail as needed and as little as possible. Should you run into any difficulty with this assembly you can get in touch with us via sales@zaorstudiofurniture.com to set up a Skype session or phone call.
8 11 6 6 7 9 3 2 1 10 Part Floor cross bar 4 5 12 Part Back stabilising cross bar Parts Part table top Keyboard tray and back panel Parts Rack dividers (2 pcs) 4 2 1 Part n Back bottom part of racks 3 5 6 Part Top bridge Part Cable tray module Parts and Left and right sideparts Part Stabilising bar for keyboard tray 9 7 8 10 12
6 8 6 7 6 6 STEP 1 Lay part flat on the ground add system bolts and lower the dividers onto panel 7 Using the bolts as guide, join the pieces together and tioghten with excenters (see page 2) 7 STEP 2 Now insert bolts into the top bridge and lower it down onto the dividers carefully aliging bolts and holes and tighten with excenters. 4 12 3 3 11 STEP 3 Lay the keyboard tray n° 3 on the ground and using bolts and excenters fixate part excenters.
4 4 3 6 3 7 8 2 1 6 8 7 11 11 12 12 STEP 5.1 (Back view) repeat step 4 for the top module ncluding STEP 5.2 (Back view) Do the same for the stabiliser bars 1 and parts 2. 6,7,8 and tighten with excenters. 9 4 5 3 1 12 6 8 2 7 2 1 3 11 11 7 8 6 12 STEP 5.3 STEP 5.4 Finally add the table top, part Now also add on the cable tray element 9 and tighten. attach and tighten.
10 10 8 9 1 2 5 2 1 3 7 5 11 8 6 7 12 STEP 6 The end is near.... Now lower down the right side part after inserting all of the system bolts in the inserts. Ideally in two, carefully align all the bolts and the holes in the parts previuosly attached to the right sidepart. When they all fit, gently press down side rt and use excenters to finish off the assembly of your desk. Gently push in the keyboard drawer and in two set the desk on its legs.
