User manual

At the end of the programme the selec-
tor dial must be turned to position
to
switch the machine off.
Important! If you turn the programme selector
dial to another programme when the machine
is working, the lights in the programme
progress display will start to flash to indicate a
wrong selection. The machine will not perform
the new selected programme.
Select the spin speed, Rinse Hold or No
spin option (
2
)
Select the spin speed, Rinse Hold option or
No Spin option by turning the spin speed se-
lector.
For the maximum spin speed allowed by each
programme, refer to the chapter Washing
programmes.
• The position 1300 is equivalent to 900 rpm/
min for the synthetic and wool programmes
and 700 rpm/min for the delicate wash pro-
gramme.
• The position 500 is equivalent to 500 rpm/
min for the synthetic and wool programmes
and 450 rpm/min for the delicate wash pro-
gramme.
Select the desired option by means of
buttons
7
,
8
and
9
Depending on the programme, different func-
tions can be combined. These must be selec-
ted after choosing the desired programme and
before pressing the button
6
. The relevant
light will illuminate.
Time
Quick
Daily
8h
Prewash
Extra
Rinse
Delay
Start
Start
Pause
If an incorrect option is selected, the corre-
sponding indicator lamp flashes for about 2
seconds. For the compatibility of the options
with the washing programmes, refer to the
chapter «Washing programmes».
Select the Delay Start by pressing button
5
Before you start the programme, if you wish to
delay the start, press the button
5
repeatedly,
to select the desired delay. The corresponding
pilot light will light up.
8h
4h
2h
Washing
End
Door
Delay
Start
You must select this option after you have set
the programme and before you press button
Start Pause.
You can cancel or modify the delay time at any
moment, before you press button Start
Pause.
Cancelling the delayed start after having
pressed button Start Pause :
1. Set the washing machine to PAUSE by
pressing button Start Pause.
2.
Press the button
5
repeatedly until the
light relevant to the selected delay goes
off.
3. Press button Start Pause again to start
the programme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The door will be locked throughout the delay
time (door locked light lit).
The Delay Start can not be selected with
DRAIN or SPIN programme.
Start the programme by pressing button
6
To start the selected programme, press this
button; the corresponding pilot light stops
flashing and remains lit.
On programme progress display the pilot
lights Washing and Door illuminate to indi-
cate that the appliance starts operating and
the door is locked.
9
www.zanussi.com